施乐 DC AP C7775 C6675 C5575 C4475 C3375 C3373 C2275 报 报错误代码 074-900 074-900 Feed Out Sensor 4 Static Jam参照 FIPCF-013 参照FIP智cmgnd朗cmgnd版cmgnd权。打印机维修网CF-013 IOT Sensor Static Jam参考 BSD: CH8.6, CH8.7, CH8.8, CH10.6, CH10.10, CH9.23, CH10.8 在电源 On 时、M/C 停止时 (Cycle Down/Shut Down)、Interlock Close时( 包括 Option 的所有Interlock)为cmgnd盗cmgnd取cmgnd，打印机维修网检测到 IOT 的Sensor 仍有纸张智cmgnd朗cmgnd版cmgnd权。打印机维修网·072-900 ： Feed Out Sensor 2·073-900 ： Feed Out Sensor 3·074-900 ： Feed Out Sensor 4·077-900 ： Regi. Sensor·077-901 ： Fusing Unit Exit Sensor·077-902 ： Exit 2 Sensor·077-903 ： POB Sensor·077-907 ： Duplex Path Sensor 原因 / 处理1.检查相应Sensor 上的纸片残留、 异物、 执行器恢复不良 (POB Sensor 除外 ) 或传感器脏污等智cmgnd朗cmgnd版cmgnd权。打印机维修网 2.检查该Sensor 是否运作不良智cmgnd朗cmgnd版cmgnd权。打印机维修网· Feed Out Sensor 2 (DC330[072-103] 或 DC330[077-105])(PL 10.11, PL 11.5, PL 12.6)· Feed Out Sensor 3 (DC330[073-103] 或DC330[077-106])(PL 10.11, PL 11.5)· Feed Out Sensor 4 (DC330[074-103] 或 DC330[077-107])(PL 10.11, PL 11.6a, PL 11.6b)· Regi. Sensor (DC330[077-103])(PL 15.2a, PL 14.5b)·Fusing Unit Exit Sensor (DC330[077-101])(PL 7.1)· Exit 2 Sensor (DC330[077-100])(PL 17.4)· POB Sensor (DC330[077-102] 或DC330[094-202])(PL 14.3)·Duplex Path Sensor (DC330[077-108])(PL 14.6) 3.检查后若无问题为cmgnd盗cmgnd取cmgnd，打印机维修网 则更换下列零件智cmgnd朗cmgnd版cmgnd权。打印机维修网[Feed Out Sensor 2, 3, 4]·Tray Module PWB (PL 12.5) [Regi. Sensor, Fusing Unit Exit Sensor, Duplex Path Sensor, POB Sensor]·Motor Driver Main PWB (PL 18.2) [Exit 2 Sensor]·Motor Driver Main PWB (PL 18.2)·Motor Driver Sub PWB (PL 18.2) 施乐报错误代码074-900 施乐 DC AP C7775 C6675 C5575 C4475 C3375 C3373 C2275维修呼叫报错误代码074-900